Printed at 0.2 resolution with 2 wall lines and 5% infill. Extensive supports are required but were rather easy to remove.  All DNA molecules were printed at 70%. The DNA from PDB ID 4ocb was printed,  re-heated afterwards with a hotgun, reshaped in order to fit through the pore and then finally glued to a larger single-stranded DNA molecule. The single-stranded DNA pieces were heated and shaped so that it will fit through the polymerase. The double-helix was printed, but not used as it can be reconstituted from the single strands really nicely. Small magnets were glued into the dedicated slots with plain plastic glue.