UW-DFab Boot Cover

This model has not been assessed for community use or in a clinical setting. Further optimization may be required.

Submitted by:

JeffreyILipton

Tue, 2020-07-21 00:52

Vertical Tabs

General Information

Model ID

3DPX-014691

Category

Labware & Devices

Device Use

Safety and Personal Protective Equipment

Keyword(s)

Covid19 Boot Cover

This design is meant for mass producing a boot cover. We recommend making this from SMS materials( a laminate of spunbond, melt blown and spunbond polypropylene) or from coated polypropylene. SMS provides low amounts of fluid contact. Heavy SMS may be appropriate for moderate contact with fluids

Apply texture/grip to the fabric
Stitch the ankle side of the foot section to the ankle of the upper piece including 9.75” elastic
Stitch the Heel/bottom of the bootie seam including 14.5” unstretched elastic. *Turn right side out)
Stitch center back of the upper piece insert 9.5” elastic where indicated and continue stitching through heal
Finish Boot top with 10” elastic

This design was developed by: