HEPA Face Mask (uses CPAP filters)

This model has not been assessed for community use or in a clinical setting. Further optimization may be required.

Submitted by:
Wed, 2020-05-27 12:55

Vertical Tabs

QR Code for https://3dprint.nih.gov/discover/3dpx-014443

Rating

No votes yet

Licensing

Comments

Comments

Hello - Would you mind uploading a version of the large and small masks without the interior lettering. In certain areas are the mask, this lettering is creating thin perimeters where slicing with a 0.4mm nozzle creates areas of the mask near the lettering where the mask is only 1 perimeter thick. This is likely to compromise the integrity of the airtight seal of the mask. 

Thanks!

Added two new files with "raised text" instead of "cutout text". Should only affect print time if you were trying to print without supports.

That works, thanks!