Pre- and Postprocessing Instructions
3D printing of the head-band and the bottom bracket.
The following settings are recommended to 3D-print the head band and the bottom bracket. These settings were optimized for fused filament fabrication (FFF) on an Ender 3 Pro (Creality), and should be adjusted depending on the 3D printer used.
-
Print materials: PLA
-
Print speed: 90mm/s
-
Layer height: 0.2mm
-
Infill: 15%
-
Infill pattern: Gyroid
-
Shell->3 perimeters,1.2mm, 3 lines
-
Top/bottom fill parameters: 0.8mm 2 layers
-
Temperature: Printer - 185-200C, Bed - 60-70C