IC3D Budmen Face Shield - Repaired

This model has not been assessed for community use or in a clinical setting. Further optimization may be required.

Submitted by:

3DLirious

Wed, 2020-04-15 19:17

Vertical Tabs

General Information

Model ID

3DPX-013879

Category

Labware & Devices

Keyword(s)

face shield PPE 3D Printing

This is a repaired version of the IC3D Budmen Face Shield V1. The original was not manifold and had some internal faces where the side tabs meet the body. Model was repaired using Blender and MeshLab.

How to Make

Printer Technology/Material

Material Extrusion

Printer Make/Model

Raise3D N2

Print Units

Printer-specific Build Instructions

Specific material

PLA

Number of prints per build

Build time

3h 24m

Pre- and Postprocessing Instructions

Recommend using a 0.6 nozzle diameter to greatly speed up printing. Suggested settings:

Face Shield

Nozzle diameter: 0.60 mm

Extrusion width: 0.72 mm (chosen so that the thin wall will print with exactly two perimeters and no internal gap or infill)

Layer height: 0.4 mm

Top/bottom solid layers: 3

Perimeters: 2

Infill: 30%

Strap locks

Same as above except:

Extrusion width: 0.60 mm (chosen so that there will be solid infill between the walls with no gaps)

Attribution

Attribution Instructions

Repaired by 3DLirious

http://3dlirious.com/

Original is attributed to IC3D, Inc. and Budmen Industries.

https://ic3dprinters.com/

https://budmen.com/

IC3D Budmen Face Shield - Repaired

This model has not been assessed for community use or in a clinical setting. Further optimization may be required.

I Printed This

Remix It

Vertical Tabs

STL/VRML Files

X3D Files

Other Files

Rating

Licensing

Comments

0