U.S. Department of Health and Human Services  —  National Institutes of Health

HEPA Mask

This design has been tested and is suitable for community use, but at this time does not meet the full requirements for use in a clinical setting.

Submitted by:
Thu, 2020-04-09 11:18

I Printed This

Remix It

Vertical Tabs

QR Code for https://3dprint.nih.gov/discover/3dpx-013693

Rating

1
Average: 1 (2 votes)

Licensing

mask out of printer
mask on build platform no support needed for FDM or SLA or DLP or LCD printers
another view
mask on right with filter in place
mask in right with filter and valve
silicone seal material used
final

Comments

1

View Comments

Comments

Mon, 2020-05-04 14:38

Hi Renne!  I like your mask design the best out of the ones I've seen.  It looks like some of the files are mislabeled, could you double check and upload the models that support the i7 roomba filters?  I see a picture of a physical mask that supports clicking in an i7 filter with no modifications, but I don't see any available 3d models that are like that.

Thanks!  Would love to start printing these!