HensNest v2

This design has been tested and is suitable for community use, but at this time does not meet the full requirements for use in a clinical setting.

Submitted by:
Wed, 2020-04-08 18:34

Vertical Tabs

QR Code for https://3dprint.nih.gov/discover/3dpx-013674

Rating

5
Average: 5 (1 vote)

Licensing

Comments

Comments

Is there any way to arrange the interior lattice to tension against itself with two seperate pieces?  THe huge X configuration makes it really hardto print on a typical printer.  Most cannot print all three componenets at once.  Can you break the lattice dwon into two parts that would interlock like two lops at the end of a rope?  Ifthey interlock the bending motion shojld keep it in place above or you could move the lock ring back in to the mix or perhaps just a length of straight printed material that is stair stepped as a lock above.