Optimized DtM v3.1 Face Shield PPE, 12% faster printing, filet edges

This model has not been assessed for community use or in a clinical setting. Further optimization may be required.

Submitted by:

Tue, 2020-04-07 17:49

Vertical Tabs

General Information

Model ID

3DPX-013635

Category

Labware & Devices

Device Use

Safety and Personal Protective Equipment

Keyword(s)

PPE, 3D Printed Face Shield, face-shield, Face Shield for 3D Printing

Optimization of "DtM v3.1 Face Shield PPE"

Please read the General Information section of the original posting before printing this remix.

Changed interior wall geometry yielding 12% quicker print times
Added 0.5mm filet on edges for smoother contact points while wearing for healthcare professionals

Attribution

Attribution Instructions

Sun, 2020-04-26 20:56

Please raise pegs 2mm so fluids cant penetrate shield at gap below pegs. Like open easier to clean design.