OpenSourceGuard - 3D printed face shield with less material

This model has not been assessed for community use or in a clinical setting. Further optimization may be required.

Submitted by:

Wed, 2020-04-01 19:10

Vertical Tabs

General Information

Model ID

3DPX-013419

Category

Labware & Devices

Device Use

Safety and Personal Protective Equipment

Keyword(s)

Face, Shield, 3D, printed

Here is our 3d printed face shield design. It does only requires a regular rubber band to secure it on head. So no need to find elastic headwrap.

You only need a 5 hole puncher to punch the holes for plastic shielding like this one: https://www.amazon.com/gp/product/B00006JNWR/ref=ppx_yo_dt_b_search_asin...

Adjust the puncher holes like in the picture attached.

12x12 inch .020 mil thickness plastic film (such as acetate or duralar film) is required for adequate protection from here: https://www.amazon.com/gp/product/B01A2U0PZW/ref=ppx_yo_dt_b_search_asin...

How to Make

Printer Make/Model

Prusa i3 MK3S

Printer-specific Build Instructions

Specific material

PLA

Build time

1HR 30 MIN FOR 2 SHEILDS.