Geek Media
Source file located on https://3dprint.nih.gov/discover/3dpx-013830
This .gcode file with 3 units of the DtM v4 is for a 1mm nozzle and will print in 3 hours and 45 minutes.
52g of filament per unit will be extruded, and 155 for every 3-piece set printed
Layer height is .7mm and line width is 2.1mm this is the ideal setting for this nozzle diameter.
Print temp is 229-228 Degrees C for increased rigidity
No brim required
Heated bed starts at 74 Degrees C and drops to 45 for energy efficiency
Trimmed .3mm off the bottom for improved build of the strap hooks
Probably one of the most efficient remixes...
none, good to go as-is
https://3dprint.nih.gov/discover/3dpx-013830