Pre- and Postprocessing Instructions
The point of this model is to reduce the number of retractions. It is recommended that all retractions are placed 'near the end of the band' and not 'near the center'. If the part is printed with the recommended 0.375mm layers and a 0.5mm wide extrusion, it can be completed within 3 layers. This is well within the capabilities of any standard 'v6 style block' and a 0.4mm nozzle.
It is HIGHLY recommended that this part be printed in PETG. The lack of infill and reduction of retractions will create a water-tight part that can be soaked in IPA or any other appropriate disinfectant. The PETG is also more durable for everyday use.
Comments
debbielei
Thu, 2020-04-30 01:53
Permalink
One size fits all
I love the design - clean and smooth. I have a wide range of recipients / users - some needs "regular" size, and some needs XL/XXL size because it is used on top of other PPE. Is it possible to make a new version which the hooks are more wider spread, add a couple more hooks, or have a "regular" size? I hope it can be one size fits all.
BrendonBuilds
Fri, 2020-05-22 14:55
Permalink
Additional hooks
I posted a .step file with additional hooks. I'm having trouble uploading a .obj file with the additional hooks as of right now, but I will check back later and retry.