Face Shield - PNWS - Full

This design has undergone review in a clinical setting and has been found appropriate when fabricated with the printer type and materials specified.

Submitted by:
Thu, 2020-04-16 03:36

Vertical Tabs

QR Code for https://3dprint.nih.gov/discover/3dpx-013883


Average: 5 (1 vote)




General Information -> Instructions for use and assembly -> Item 1 - use a three hole punch

The shield needs six holes, I don't understand how to use a three hole punch to get six holes. What am i missing?

Hi, it is two sets of 3 hole punch spaced an inch apart. Best way to do it is make sure your middle hole is offset from the Center by half an inch, punch and then flip it over and punch again.