Scale At Given Print Units
Pre- and Postprocessing Instructions
Tested with layer size 0.28mm for faster prints. 10% infill.
Press corners from side holder and frame untill side frame gets separated from dots. You should hear some clicks. Do the same for other side. Frame should move separately from bottom layer. Use scrapper tool to brake dots on sides if not separated by hand force.
Comments
jdreitman
Mon, 2020-04-13 13:55
Permalink
Visor?
Can you tell me, is the visor portion of this print long enough to allow for a mask and goggles? It looks very narrow and just want to be sure.
jdreitman
Mon, 2020-04-13 13:56
Permalink
Stack?
Also, are you stacking this with a small layer gap between the prints? Or are you placing the second level model directly on top of the first?
hemalm
Fri, 2020-05-22 22:43
Permalink
visor response
This design has same visor length as original verkstan design. If the glasses are thick you can keep front side higher and back portion little lower. This will create more room for glasses and mask.
hemalm
Fri, 2020-05-22 22:49
Permalink
Stack response
I have not tried this model for stacking. It depends on your printer settings and layer height gaps. If you keep air gap same as one layer height it should work but bottom layer in stacked print can be rough. It can work well with higher quality settings but it adds more time in printing. Hope this helps.