3D Printed Respirator Mask

  • Printed the "Large" model on a Cetus 3D MK2 at 0.25 layer height on 'fine' mode and 13% infill
  • The print time was about 1.8 hours and required 35g of PLA
  • Used Proto Pasta's HTPLA for a smooth interface to the skin
  • The print did not require any support
  • The main goal of this build was to demonstrate compatibility with a small-build, open-source 3D printer
Printer Technology/Material 
Printer Make/Model 
Resolution (Layer Height) 
0.25
Keyword(s) 

Click to Enlarge - 4 image(s)

Rating 
1
Average: 1 (1 vote)